For current use, follow the technical data sheet and safety data sheet for the product supplied.
Precautionary note
Expansive demolition agents can produce a phenomenon known as a blowout. It occurs when the mixed powder gets too hot and reacts with water too quickly for the material to expand. The temperature can rise above the boiling point before the water has chemically combined with the expansive mortar. The result can be a sudden, forceful steam explosion.
To avoid blowouts, follow the instructions on water temperatures, mixtures and hole sizes. Always wear safety goggles. Use holes 32 mm in diameter. Remove all dust and dirt from the holes after drilling. Keep the expansive mortar in a cool place before use. Use water at a temperature below 15°.
- Expansive mortar is highly alkaline. Its pH reaches 13 on contact with water and it can cause severe irritation to mucous membranes, especially the eyes.
- Wear safety goggles and rubber gloves when mixing and filling holes with expansive mortar.
- Wear a dust mask when using expansive mortar, especially in areas with poor ventilation such as tunnels or mines.
- Stay away from the holes and, in particular, keep them open for at least 3 hours after filling them.
- Keep people away from the area after filling the holes.
- If it rains, protect the holes by covering the rock with plastic, preferably transparent.
- If expansive mortar comes into contact with the skin, remove it immediately using plenty of cold water.
- If expansive mortar comes into contact with the eyes, rinse it away immediately with plenty of cold water without rubbing. Seek medical attention promptly.
Wear gloves
Wear a mask
Wear safety goggles
Mandatory protective equipment



